Author: david_ad
Subject: Couldn't access using PSExec - PSTools
Posted: 19 September 2013 at 2:13pm
PSTools I downloaded and installed in C: \ PSTools. Then I did the following:
1 - I opened the Command Prompt
2 - C: \ PSTools> I did this: C: \ PSTools> psexec
3 - Then I did: C: \ PSTools> psexec \ \ IP-u user calc
But it returns this message:
C:\PSTools>psexec \\IP -u USER calc
PsExec v1.98 - Execute processes remotely
Copyright (C) 2001-2010 Mark Russinovich
Sysinternals - www.sysinternals.com
Password:
Couldn't access IP:
The network path was not found.
Make sure that the default admin$ share is enabled on IP.
Can you help me??
Thanks,
Subject: Couldn't access using PSExec - PSTools
Posted: 19 September 2013 at 2:13pm
PSTools I downloaded and installed in C: \ PSTools. Then I did the following:
1 - I opened the Command Prompt
2 - C: \ PSTools> I did this: C: \ PSTools> psexec
3 - Then I did: C: \ PSTools> psexec \ \ IP-u user calc
But it returns this message:
C:\PSTools>psexec \\IP -u USER calc
PsExec v1.98 - Execute processes remotely
Copyright (C) 2001-2010 Mark Russinovich
Sysinternals - www.sysinternals.com
Password:
Couldn't access IP:
The network path was not found.
Make sure that the default admin$ share is enabled on IP.
Can you help me??
Thanks,
